В эльзе на англ., только такое....
EVAP Canister System Assembly Overview
Notet Components marked with * are checked via On Board Diagnostic (OBD).
* Components marked with ** are checked via output Diagnostic Test Mode.

1 - From Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-*/**
2 - Seal
* Replace if damaged
3 - Vent line
4 - Connection piece
5 - Connector
* 3-pin
6 - Vacuum line
* To Throttle Valve Control Module -J338- → Item
7 - Leak Detection Pump (LDP) -V144-*/**
* Under wheel housing liner in right rear wheel housing
* Checking, refer to → Chapter „Leak Detection Pump, Checking“
8 - Connecting hose
* Pressure side
9 - 3 Nm
10 - Air filter for Leak detection pump (LDP) -V144-
11 - Connecting hose
* Suction side
12 - Bracket
13 - 10 Nm
14 - EVAP canister
* Under wheel housing liner in right rear wheel housing